Place of Origin:
China
Brand Name:
SLAPK
Certification:
CE, ISO9001
Model Number:
200QJH20-230/17
Our 200QJH20-230/17 is a 17-stage deep well pump for water supply to drip irrigation systems. A 25 kW motor drives it at a nominal flow of 20 m³/h and a nominal head of 230 m.
This model can be assessed where the combined well lift, delivery elevation, pipeline losses and irrigation inlet pressure require its head capability. Pressure regulation may be needed before the drip network.
The hydraulic components are cast stainless steel. Water enters at the inlet section, passes through the impellers and diffusers and leaves through the 2.5 inch outlet.
Drip irrigation is the intended application area. A drip network needs a defined inlet pressure at the filter station and main line, and that pressure is only one part of the total head the pump has to produce.
The pump can also be assessed for filling a storage tank that supplies the drip irrigation system. This arrangement separates tank filling from irrigation demand, although changes in well and tank water levels can still affect the pump's operating point.
The hydraulic components are manufactured by casting. The stainless steel grade and component scope are specified in the quotation according to the water quality and project requirements.
1. Catalog ranges and the operating point. The flow and head figures above are the catalog ranges listed for this model. The required operating point must be checked against the performance curve for the quoted configuration. The maximum catalog flow and maximum catalog head should not be combined as a guaranteed operating point.
2. Total head includes the irrigation inlet pressure. The head the pump must produce is the pumping water level below the wellhead, plus the delivery elevation, plus the friction loss in the rising main and pipeline, plus the pressure required at the irrigation inlet. Ignoring the pressure required at the irrigation system inlet can underestimate the total head and result in insufficient operating pressure.
3. Well diameter is confirmed from the drawing. The 2.5 inch figure is the discharge connection, not the outside diameter of the pump. The 200 in the model name identifies the catalog series, and the required borehole diameter is confirmed from the installation drawing for the selected assembly.
The motor rating for this model is 25 kW. Please provide the supply voltage, frequency and phase. The motor rating, rated current and electrical configuration will be confirmed for the selected assembly. Performance data will correspond to the specified frequency.
Cable length and conductor size are selected according to the complete cable route, motor rating, supply voltage, voltage drop and installation requirements. The supplied cable specification will be stated in the quotation.
Each pump is built to the configuration confirmed on the order, tested at our works before packing, and released for delivery after it passes.
The quotation will specify the supplied motor lead cable, any extension cable, control equipment and accessories.
Do not run the pump dry. The installation must maintain the minimum submergence and motor cooling conditions specified for the selected assembly.
The minimum order quantity is to be confirmed in the quotation. Lead time will be stated in the quotation based on the order configuration and quantity. Warranty terms will be specified in the quotation. Packing is specified in the quotation.
1. Is this pump suitable for a drip system?
It can be assessed where the combined well lift, delivery elevation, pipeline losses and irrigation inlet pressure require its head capability. Pressure regulation may be needed before the drip network.
2. What is the difference between this model and the 216 m version?
One more stage and a higher nominal head at the same nominal flow. The suitable choice depends on the confirmed total head of the installation, not on the irrigation method.
3. Which stainless steel grade is used?
The stainless steel grade and component scope are specified in the quotation according to the water quality and project requirements.
4. What is included in the supply?
The quotation will specify the supplied motor lead cable, any extension cable, control equipment and accessories.
5. What should we send for a quotation?
The required flow and total head, well data, water levels, irrigation inlet pressure, pipeline data, supply voltage, frequency and phase, quantity and destination.
To assess this model and prepare a quotation, please send us:
You can leave any item you do not know blank. We will check the operating point on the performance curve and reply with the configuration, price and lead time.
Send your inquiry directly to us