Place of Origin:
China
Brand Name:
SLAPK
Certification:
CE, ISO9001
Model Number:
200QJH20-256/19
Our 200QJH20-256/19 is a 19-stage deep well submersible pump for livestock farm tank filling. A 30 kW motor drives it at a nominal flow of 20 m³/h and a nominal head of 256 m.
The pump can be assessed for transferring well water to a livestock farm storage tank. The required flow is based on daily water demand and the available refill time. Direct supply to trough lines requires a separate review of pressure control and changing demand.
The hydraulic components are cast stainless steel. Water enters at the inlet section, is lifted through the stages and leaves through the 2.5 inch outlet.
Livestock farm tank filling is the intended application. The pump fills a storage tank and the daily volume follows the running hours, so the tank capacity and the refill window set the flow requirement.
Where water is drawn from the tank to troughs, the trough line is a separate system with its own pressure and control requirements and is reviewed separately.
The hydraulic components are manufactured by casting. The stainless steel grade and component scope are specified in the quotation according to the water quality and project requirements.
1. Catalog ranges and the operating point. The flow and head figures above are the catalog ranges listed for this model. The required operating point must be checked against the performance curve for the quoted configuration. The maximum catalog flow and maximum catalog head should not be combined as a guaranteed operating point.
2. Total head includes the tank fill point. The head the pump must produce is the pumping water level below the wellhead, plus the delivery elevation to the tank inlet, plus the friction loss in the rising main and the filling line.
3. Well diameter is confirmed from the drawing. The 2.5 inch figure is the discharge connection, not the outside diameter of the pump. The 200 in the model name identifies the catalog series, and the required borehole diameter is confirmed from the installation drawing for the selected assembly.
The motor rating for this model is 30 kW. Please provide the supply voltage, frequency and phase. The motor rating, rated current and electrical configuration will be confirmed for the selected assembly. Performance data will correspond to the specified frequency.
Cable length and conductor size are selected according to the complete cable route, motor rating, supply voltage, voltage drop and installation requirements. The supplied cable specification will be stated in the quotation.
Each pump is built to the configuration confirmed on the order, tested at our works before packing, and released for delivery after it passes.
The quotation will specify the supplied motor lead cable, any extension cable, control equipment and accessories.
Do not run the pump dry. The installation must maintain the minimum submergence and motor cooling conditions specified for the selected assembly.
The minimum order quantity is to be confirmed in the quotation. Lead time will be stated in the quotation based on the order configuration and quantity. Warranty terms will be specified in the quotation. Packing is specified in the quotation.
1. How much water can this pump deliver per day?
The daily volume follows the running hours at the nominal flow. Tell us the daily demand and the refill window, and we will check whether the flow and the running time fit.
2. Can it supply trough lines directly?
Direct supply to trough lines requires a separate review of pressure control and changing demand. The normal arrangement is to fill a storage tank and supply the troughs from the tank.
3. Why does this model use a 30 kW motor?
The nineteenth stage adds head, so the shaft power at that operating point needs the larger motor. The electrical configuration is confirmed for the selected assembly.
4. Which stainless steel grade is used?
The stainless steel grade and component scope are specified in the quotation according to the water quality and project requirements.
5. What should we send for a quotation?
The required flow and total head, well data, water levels, tank capacity and fill point height, supply voltage, frequency and phase, quantity and destination.
To assess this model and prepare a quotation, please send us:
You can leave any item you do not know blank. We will check the operating point on the performance curve and reply with the configuration, price and lead time.
Send your inquiry directly to us